
Drawing Basic Shapes
If, when you are in gluepoint edit mode, you click on the button, you can add a
new possible direction to a gluepoint. If we keep the preceding example, this would
give:
The addition of this extra direction enabled OpenOffice.org to draw a shorter
connector.
When this button is pressed (as it is by default), any resizing of an object will cause
gluepoints to move with the associated object. If this button is deactivated, the
gluepoint will not move, as shown by the following illustrations:
When the button is deactivated, the last six buttons on the toolbar that were grayed
out now become usable. These buttons let you choose how the glue points will be
rearranged when the object is re dimensioned.
These three buttons let you choose the horizontal positioning of the gluepoint. You
can choose to maintain the same position with respect to the left edge (1
st
button),
with respect to the center (2
nd
button) or with respect to the right edge (3
rd
button).
These three buttons let you choose the vertical positioning of the gluepoint. You
can choose to maintain the same position with respect to the upper edge (1
st
button), with respect to the center (2
nd
button) or with respect to the lower edge (3
rd
button).
Draw Guide 23
Kommentare zu diesen Handbüchern